Powermax 600 operator manual

See warnings on page before proceeding. The AC voltage between any 2 input wires should equal the line voltage. Installation - See Figure Installation - Refer to Figure CAUTION:Do not tighten the strain relief collar 4 onto the torch lead until the gas fitting 3 is tight, or the gas connection may leak.

Refer to Figure Compress the hose fitting collar and pull the gas hose from the hose fitting. Pull the drain hose from the grommet in the floor of the power supply.

Install the new filter element into the filter housing. Secure with screw and retainer. Install the filter bowl and O-ring into the filter housing. Push the pressure line fully into the hose fitting. Install the drain hose into the grommet. Install the strain relief 1 to the power supply and secure with nut 2.

Install work cable 3 through the strain relief. Tie a knot 4 in the end of the work cable. Disconnect electrical power and gas supply before removing the power supply cover. Remove screws securing capacitor to PC board. Remove capacitor from fan side of power supply. Capacitor Identification Installation - Refer to Figure Power Capacitor Supply Use thermal grease on components A and B. Install components to the heat sink as shown Apply a thin coat to the component, install with below.

Use a new thermal pad on components C. These cookies will be stored in your browser only with your consent. You also have the option to opt-out of these cookies. But opting out of some of these cookies may have an effect on your browsing experience. Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.

Skip to content. This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Privacy Overview This website uses cookies to improve your experience while you navigate through the website. Privacy Overview. Necessary Always Enabled. Do not the operator to turn off the power supply quickly in substitute other torches which could overheat and an emergency situation.

Fasten the retaining nut ground, in accordance with appropriate national or tightly. Box , Miami, FL Government Printing Office, Washington, D. Page Warning Label Use welding helmet with correct shade of filter. Wear complete body protection. Become trained and read the instructions before working on the machine or cutting. The hand torches must have shielded consumable parts to maintain S mark compliance. IEC Symbols Used The following symbols may appear on the power supply data plate, control labels and switches.

Do not lift the power supply by ONE handle. The handle can break, resulting in injury and damage to the power supply. Hoist Approved hoisting strap. The plug should be connected to the power cord by a licensed electrician. Extension Cord Use a cord that is certified by national or local codes.

The cord should be installed by a licensed electrician. Refer to the length requirements listed below. Page 27 1. Set the generator output to AC. Plug the Powermax power cord into the auxiliary power outlet. Set the generator to the appropriate output range. If the Powermax circuit breaker will not stay on, reduce the generator output. Key-way Before tightening, align threads by turning one turn counterclockwise. Contaminants can damage the power supply, torch and consummables.

Pieces of tape can enter the air line and damage the system. The plasma arc will quickly cut through gloves and skin. Make sure power is off before changing consumables. Hand tighten only. Use to cut expanded metal.