Altronix al175ulx manual
See Terminal Identification Chart on page 3 for a description of each terminal function. Mount the unit in the desired location. Mark and predrill holes in the wall to line up with the top two keyholes in the. Install two upper fasteners and screws in the wall with the screw heads protruding.
Place the enclosure's. Mark the position of the lower two holes. Remove the. Drill the lower holes and install the two fasteners. Place the enclosure's upper keyholes over the two upper. Install the two lower screws and make sure to tighten all screws Enclosure Dimensions, pg.
Minimum 0. Shut branch circuit power before installing or servicing equipment. There are no user serviceable parts inside. Refer installation and servicing to qualified service personnel. Power Supply Output Specification Table. Measure output voltage before connecting devices. This helps avoiding potential damage. Installation Instructions:. Output cont'd. Battery Backup:. Enclosure Dimensions:. ALULX - 3 -. Measure output voltage before connecting devices.
This helps avoiding potential damage. Use two 2 12VDC batteries. Note: For Access Control applications batteries are optional. When batteries are not used, a loss of AC will. When the use of stand-by batteries is desired, they must be lead acid or gel type. Panel or to visual AC trouble indicator. Secure enclosure door with the screws supplied to assure proper ground. Unit should be tested at least once a year for the proper operation as follows:. Output Voltage Test : Under normal load conditions the DC output voltage should be checked for proper.
Battery Test : Under normal load conditions check that the battery is fully charged, check specified. Note: Maximum charging current under discharges is mA.
0コメント