Sf340 manual

Fit the outer cover of the unit by pushing until the clips at either end. Turn on the electrical supply. Check that the green power light. Remove the outer cover of the unit by gently pushing in the 2. Remove the power supply unit by pushing in the. Push the test button and hold until the audible alarm signal is given. Decide where the electrical supply cable is to enter the unit and. If the wiring to. The unit has been designed to be either surface or flush. Remove the outer cover of the unit by gently pushing in the clips.

Remove the module fixing screw if fitted and unclip. Mark the position of the 2 mounting holes, drill two 5mm. This applies even if the primary power. If no. Using a standard 2 gang 28mm mounting box, complete the. Push the test button and hold until the audible alarm signal is. The unit is now ready and working. The SFE must be supplied from a non-switched 3 Amp. Only the following batteries are suitable replacements for the.

Connect the supply wiring to the 3 way terminal block. Maximum wire size is 2. To replace the backup battery, remove the Module from the unit.

Refit the Module and outer cover to the unit and push and hold. If your alarm sounds, please proceed as follows:. Connect the brown wire of the power supply unit to the red or. Connect the blue wire of the power supply unit to the black.

The earth wire can be sleeved and connected to the third. Once all electrical connections are made, locate the terminal. Fit the power supply unit to the base ensuring that the wires sit.

Check that the power. Secure the power supply in place by tightening the securing. Important: The power supply securing screw must be tight-. Important: The power supply securing screw must. Important: The power supply securing screw must be. EN CAS. On ne de doit pas le heurter ou le faire.

Il n'offre aucune protection contre les risques d'intoxication. Du monoxyde. Ne pas peindre. Un voyant d'alimentation vert indique que l'appareil est sous tension. Tester l'alarme toutes les semaines en appuyant sur le bouton de. Il convient de rappeler que, si des. Keep their number in a prominent.

In the case of. Au cours de. Toutefois, nous ne sommes aucunement. Les appareils. Il doit. Le voyant d'alimentation vert continue de clignoter environ. On doit alors remplacer la pile. Le voyant rouge clignote. Voir la section 10 sur le.

Avertissement de remplacement du module. On doit. Le voyant rouge clignote toutes les Du fait qu'il est. Le voyant d'alimentation vert s'allume lorsque la source. En fonctionnement normal, le voyant rouge clignote une fois par. En cas d'alarme, il clignote cinq fois. Air lourd dans les tuyaux air froid humide avec longues. Obstructions dans les conduites de refoulement ou conduites.

Le relais offre un contact de commutation unipolaire SPCO pouvant. Le courant. Voiture dont le moteur tourne dans un garage ouvert ou contigu. Si un des appareils se met en alarme,.

On identifie facilement. Lorsque l'alarme cesse sur l'appareil, le. Au bout de 90 secondes,. On signale, dans un grand nombre de cas d'intoxication au. Cependant, si vous disposez de plusieurs appareils de chauffage. Enlever le bloc d'alimentation en poussant sur. Chauffer de l'air les naturellement ascensions ; c'est pour mieux. Le SF Feuilleton. Marquer l'emplacement des 2 orifices de montage, percer deux.

Raccorder le conducteur marron du bloc d'alimentation au. Raccorder le conducteur bleu du bloc d'alimentation au. On peut gainer le fil de terre et le raccorder. Il est. BS Normal Module Operating Life: 5 years. Backup Battery Life when in Alarm: At least 5 days. Dimensions: mm x mm x 65mm. W eight: Approximately g.

During this period we will,. W e shall, however , be under noobligation to repair , replace or. Defective units.

An accompanying letter should. This guarantee does. Thank you for purchasing this alarm which is designed to detect. This manual contains. Carbon Monoxide is a highly poisonous gas which is released. It is invisible, has no smell and no taste,. Under normal operating conditions, in a room where fuel.

A dangerous quantity of Carbon Monoxide can occur if one or. The following conditions can result in transient Carbon Monoxide. Excessive spillage or reverse venting of fuel burning appliances. Heavy air in the vent pipes cold humid air with. Negative pressure differential r esulting from use of exhaust fans.

Simultaneous operation of several fuel burning appliances. Flue connections br eaking loose from clothes dryers, water. Extended use of unvented fuel bur ning devices. T emperature inversions which can trap exhaust gases near the. A car running in an open or attached garage near a home. The following symptoms are related to Carbon Monoxide. Mild exposure: Slight headache, nausea, vomiting, fatigue.

Medium exposure: Severe throbbing headache, dr owsiness,. Extreme exposure: Unconsciousness, convulsions,. Many reported cases of Carbon Monoxide poisoning indicate that. It is also important to. Ideally you should have an alarm in or near every room which. However , if you have more than one appliance but only one alarm,. Carbon Monoxide has a similar density to warm air.

T o ensure the. Warm air naturally rises; it is better to install the. This is to ensure. When the unit is powered from the primary power sour ce e.

The gr een. This indicates the alarm is. When the unit detects Carbon Monoxide, the alarm signal is given. When the unit has been in alarm for a period of 40 minutes, the. When the Carbon Monoxide disperses, the alarm will automatically.

When the backup battery in the SFM module needs replacing the. The battery must then be replaced. See Section 10 on batteries. When the module SFM needs replacing, the audible alarm will. At this time the module. All units are powered by a primary power sour ce e. The green power light will illuminate when the primary power.

In the alarm condition the buzzer will sound. The green power light will illuminate when the primary power. In the alarm condition the buzzer will sound. Models SFE,. All models in the SF series have a battery backup feature. All models in the SF series have a test button. This is. If the relay and. The relay provides a single pole changeover SPCO volt fr ee. The relay contacts are rated at 3A. When the unit comes. If one unit goes into the alarm. This alarm signal is a continuous tone.

The unit that caused the. When the unit comes out of the. After a delay of 90 seconds the buzzers of all interconnected units. Select a suitable location to install the alarm see Section 4. The model number and supply voltage are marked on the power. Remove the outer cover of the unit by gently pushing in the 2.

Remove the power supply unit by pushing in the. Decide where the electric al supply cable is to e nter the unit and. If the wiring to. Mark the position of the 2 mounting holes, drill two 5mm.

Using a standard 2 gang 28mm mounting box, complete the. The SFE must be supplied from a non-switched 3 Amp. Connect the supply wiring to the 3 way terminal block. Maximum wire size is 2. Connect the brown wire of the power supply unit to the r ed or. Connect the blue wire of the power supply unit to the black. No connection must be made to the mains supply earth.

The earth wire can be sleeved and connected to the third. Once all electrical connections are made, locate the terminal. Fit the power supply unit to the b ase ensuring that the wires sit.

Check that the power. Secure the power supply in place by tightening the securing. Important: The power supply securing screw must be tight-. No external fuse is required. Maximum wire size is. Connect the black or blue neutral wire of the supply to the. Refer to later section for Relay and Interconnect Connections.

Important: The power supply securing screw must. The SFJ must be supplied. No exter nal fuse is. Connect the positive supply wire. Connect the negative supply wire 0V to the terminal marked 0V. No connection must be made to the supply earth. Refer to following section for Relay and Interconnect Connections. The relay connections are made using the terminal block on the. Connections to the relay.

COM — Common. The interconnect system is made using the terminal block on the. Units are connected. SFJ alarms. Alarm 1 Alarm 2 Alarm 3.